Ansicht
Dokumentation

CPA58F9 - Line &23 failed while attached to network interface &30. Addressing problem encountered (C G R) ( OS/400 )

CPA58F9 - Line &23 failed while attached to network interface &30. Addressing problem encountered (C G R) ( OS/400 )

BAL Application Log Documentation   Vendor Master (General Section)  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA58F9
Line &23 failed while attached to network interface &30. Addressing problem encountered (C G R)

Message Long Text :

Cause . . . . . : The local system has encountered a problem with its terminal end point identifier (TEI) used for communication with the network on network interface &30. This situation resulted in the failure of line &23. The probable causes are:
-- Another device having a duplicate TEI is attached to the same interface as the local system (passive bus configuration).
-- If using a non-automatic terminal end point identifier, the value specified for the terminal end point identifier (TEID) parameter in the network interface is incorrect or the network is assuming automatic TEI assignment.
-- A network problem.
-- The network type (NETTYPE) parameter is not set correctly in network interface &30.
Recovery . . . : Do one or more of the following:
-- Ensure that other attached devices, if any, are using valid TEIs.
-- If using a non-automatic terminal end point identifier, use the Work with Network Interface Description (WRKNWID) command to ensure that the value specified for the TEID parameter is correct.
-- Verify that the network is operational.
-- Use the Work with Network Interface Description (WRKNWID) command to ensure that the value specified for the NETTYPE parameter is correct.
Reply to the message.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel recovery and inform any applications and subsystems that are waiting for an operation that the recovery has been canceled.
G -- Start the automatic communications recovery again as defined by the communications recovery limits (CMNRCYLMT) parameter configured for line &23.
R -- Try again one more time.
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40, and has the following meaning:
46002570 - Automatic TEI assignment procedure failed.
4600257D - TEI was removed by the NT.

Message File : QCPFMSG
Library Message File : QSYS2924


Addresses (Business Address Services)   SUBST_MERGE_LIST - merge external lists to one complete list with #if... logic for R3up  
This documentation is copyright by IBM.

Length: 3311 Date: 20240329 Time: 145614     sap01-206 ( 3 ms )