Ansicht
Dokumentation

CPA59C9 - Line &23 failed. HDLC frame retry limit exceeded. (C N R) ( OS/400 )

CPA59C9 - Line &23 failed. HDLC frame retry limit exceeded. (C N R) ( OS/400 )

PERFORM Short Reference   RFUMSV00 - Advance Return for Tax on Sales/Purchases  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA59C9
Line &23 failed. HDLC frame retry limit exceeded. (C N R)

Message Long Text :

Cause . . . . . : The high-level data link control (HDLC) frame retry limit was exceeded prior to receiving an acknowledgement from the network. The probable causes are:
-- The X.25 network is not currently ready for switched X.25 access. If interconnected using a modem eliminator or its equivalent, the remote system is not ready for an HDLC link connection.
-- The idle timer (IDLTMR) parameter value configured in line description &23 is not long enough to account for the total round trip delay and the quality of the lines to the network.
-- The connection initiation (CNNINIT) parameter value is not compatible with the value used by the X.25 network.
-- The X.25 DCE support (X25DCE) parameter value is not correct.
-- If the interface (INTERFACE) parameter in the line description is not *X31, the telephone number supplied in the connection number (CNNNBR) parameter is not correct.
-- If the interface (INTERFACE) parameter in the line description is *X31, the remote number (RMTNBR) parameter supplied in connection list entry &46 of connection list &45 is not correct.
Recovery . . . : Do one or more of the following:
-- Use the Work with Line Description (WRKLIND) command or the Work with Connection List (WRKCNNL) command to correct the parameters in error.
-- Contact your network administrator.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel the dial attempt to the X.25 network and all logical calls waiting for the connection. Any applications and subsystems that are waiting for an operation will be informed that the logical call has been canceled.
N -- Cancel the dial operation to the X.25 network using line &23, and try to complete the pending logical calls. Depending on the values specified for the switched line list (SWTLINLST) and the switched line selection (SWTLINSLCT) parameters configured in each controller description, the system may choose a different line description to complete the call.
R -- Try the operation one more time when line &23 is available.
Technical description . . . . . . . . : The error log identifier is &22.
The error code is &40: HDLC data link frame retry limit reached.

Message File : QCPFMSG
Library Message File : QSYS2924


TXBHW - Original Tax Base Amount in Local Currency   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3269 Date: 20240328 Time: 182146     sap01-206 ( 2 ms )