Ansicht
Dokumentation
00599 - Installing 3.1H on V4R4
Vendor Master (General Section) ABAP Short ReferenceThis documentation is copyright by SAP AG.
Installing 3.1H on V4R4
Hi,I went through the same experience last month installing a 31h instance on
v4r5. I applied the 31i kernel when the post install step failed as r3 came
up then down, since the 31h kernel wasn't certified for v4r5. I used the
latest 31i kernel cd (51011233) to install, then applied the additional
patches for 31i kernel from sapserv. When I restarted the 31h install it
failed again, but only because it picked up with running the post install
reports as its first step. It assumed that R3 was already running and hadn't
crashed. So I just manually brought up R3 (with the 31i kern), then
restarted the 31h install, and it completed the post install steps without
another hitch.
Hope this helps,
Rich
-----Original Message-----
From: mmackZw... [mailto:mmackZw...]
Sent: Thursday, February 01, 2001 2:00 PM
To: sap400Zm...
Subject: Installing 3.1H on V4R4
Good afternoon, I'm installing our 3.1H system on a AS400 V4R4M0 , which
is where our 4.5B system already resides. The install failed after the
second DB load CD finished and the message queue requested the Kernel CD.
The system replied to the message with a *N, which caused the install to
fail. I never had the chance to load the kernel CD for the post
installation files to be loaded. If I choose option 3 to install again
will the process begin were it left off or do I have to run the whole
installation again? Is their a way to load the post install files without
doing the install again. Thanks again for your help.
To unsubscribe from this group, send an email to:
SAP on System i-unsubscribeZegroups.com
Durban Tours - Südafrika Safari
CL_GUI_FRONTEND_SERVICES - Frontend Services General Data in Customer Master
This documentation is copyright by SAP AG.
Length: 2607 Date: 20240420 Time: 020814 sap01-206 ( 2 ms )
