Ansicht
Dokumentation
03012 - ALV scrolling?
ROGBILLS - Synchronize billing plans General Material DataThis documentation is copyright by SAP AG.
ALV scrolling?
Jim,
We've had similar problems with some of the MBxx transactions in 4.5B, and
were given manual patches to table T185 (OSS Note 187089). Missing records
in T185 are *usually* the reason the scroll-button refuse to work.
Hope this helps ---
Brian Zugel
SAP America
-----Original Message-----
From: Jim Doll [mailto:jdollZp...]
Sent: Tuesday, August 21, 2001 4:56 PM
To: sap400Zm...
Subject: ALV scrolling?
I need some advice from someone with more ABAP List Viewer experience than
what I have (which is practically anybody....)
We're on 4.6C, using transaction MB56. We're starting to use transaction
BMBC, which calls something that looks suspiciously like MB56. In each
case, we're presented with a screen that scrolls poorly: if we fill several
screens with bottom up or top down, we can't easily scroll through the data.
For example, with MB56, bottom-up analysis:
- I bring up the initial screen, and expand it fully with the double-down
arrow.
- My "top", "bottom", "page-up", and "page-down" arrows on the top are not
active.
- My scroll bar on the right, if it is proportional, shows I'm looking at
about half of the available data.
- If I scroll down by clicking below the scroll bar, I go down a page and
the scroll bar indicates that I'm at the bottom, but there is still more
information to be shown. At this point, clicking above or below the scroll
bar does the same thing as pressing the "page-up"/"page-down" keys on the
keyboard.
- If I click inside the screen, in the list, my scroll bar doesn't change,
but now I can use the "page-down" key to see stuff past what I was looking
at before.
There's no consistency with any other screen processing that I've seen in
SAP-land. We put in an earlier question on this problem, and were told that
a kernel patch was supposed to make it better, but that it was operating as
designed. We've put that patch on a test environment, and it seems to act
the same.
Is anyone else familiar with this problem? Is this just the way that ALV
works, or is this screen goofy, or something else? I think it is just
poorly done; other users here at the company are telling me that it is
unacceptable. What are my options?
Thanks in advance....
Jim Doll, Perrigo
To unsubscribe from this group, send an email to:
SAP on System i-unsubscribeZegroups.com
Your use of consolut is subject to http://www.consolut.net
Durban Tours - Südafrika Safari
Vendor Master (General Section) Addresses (Business Address Services)
This documentation is copyright by SAP AG.
Length: 3397 Date: 20240416 Time: 093243 sap01-206 ( 3 ms )
