Ansicht
Dokumentation
05245 - Backup of Journalreceivers
ABAP Short Reference TXBHW - Original Tax Base Amount in Local CurrencyThis documentation is copyright by SAP AG.
Backup of Journalreceivers
Hi Volker,sometimes in the past we were advised by SAP to decrease the
RCV-size-threshold from 2 GB to 500 MB. Don't ask me what for.
When I now set this threshold up to 1 TB, will it cause any trouble, i.e. do
I have to adjust any additional screws before doing that?
Regards,
Franz
Franz Lehnardt
AS/400 & R/3 Basis Administration
EGG IT Services GmbH
Eschborn, Germany
Tel. ++49 (0) 6196 477-360
Fax ++49 (0) 6196 477-776
-----Ursprüngliche Nachricht-----
Von: Gueldenpfennig, Volker
[mailto:volker.gueldenpfennigZs...]
Gesendet am: Mittwoch, 27. Februar 2002 15:37
An: 'franz.lehnardtZe...'
Cc: Sap400 (E-mail)
Betreff: RE: Backup of Journalreceivers
Hi Franz,
I would recommend the following:
V4R5:
CHGJRN JRN(R3SIDDATA/QSQJRN) RCVSIZOPT(*MAXOPT1)
V5R1:
CHGJRN JRN(R3SIDDATA/QSQJRN) RCVSIZOPT(*MAXOPT2)
Then the journal receivers can grow up to 1 GB, because I guess,
that the
problem is, that the system is not able to change the receiver
before it
reached 2GB which is normally the maximum.
Regards
Volker
> -----Original Message-----
> From: Lehnardt, Franz [mailto:franz.lehnardtZe...]
> Sent: Mittwoch, 27. Februar 2002 15:08
> To: 'SAP on System i (E-Mail)'
> Subject: Backup of Journalreceivers
>
>
> Hi all
>
> another poll to the group:
>
> I wonder, how you out there do manage the backup/archive of
> your JRNRCVs?
> How much traffic do you have on your journal?
> How often and in which way do you backup your receivers?
>
> The background of my questions:
>
> Once we used BRMS function "Archive" to handle the daily
> backup of our R/3
> JRNRCVs. But it happened sometimes that our PRD system came
> to a complete
> hold because of the Archive job locked the entire PRD journal, so
the
> current RCV couldn't get changed when it reached its
> threshold. Msg CPI70E5
> "Journal or Journalreceiver not available" was issued.
>
> An additional reason for that conflict was the fact, that the
> rate of RCV
> changes on our system is at some times of day very high (less
> than 5 min.),
> so when the Backup Job runs for about 10-15 minutes, the
> current receiver is
> guaranteed to crash against the wall...
>
> Finally we set a manual procedure which is still in use today:
>
> WRKJRNA to check, what JRNRCVs are in status ONLINE
> SBMJOB with command SAVOBJBRM where the known receiver
> numbers are entered.
> This way we make sure, that all the receivers which will be
> attached during
> the backup will not get locked
> Last step: Delete all saved receivers also manually.
>
> But this manual input is risky (the human IT-component...)
> and sure enough -
> this week we had another PRD stop, because of accidentially
> saving the wrong
> receiver-number. Now we think of an alternative, fully or
> partly automatted.
>
> Any insight will help, thanks a lot in advance.
>
> Franz Lehnardt
> AS/400 & R/3 Basis Administration
> EGG IT Services GmbH
> Eschborn, Germany
> Tel. ++49 (0) 6196 477-360
> Fax ++49 (0) 6196 477-776
>
>
Durban Tours - Südafrika Safari
CPI1466 during Backup TXBHW - Original Tax Base Amount in Local Currency
This documentation is copyright by SAP AG.
Length: 4277 Date: 20240420 Time: 121514 sap01-206 ( 2 ms )
