Ansicht
Dokumentation

09028 - Antwort: No Transports an TP Process in st atus END

09028 - Antwort: No Transports an TP Process in st atus END

Vendor Master (General Section)   Addresses (Business Address Services)  
This documentation is copyright by SAP AG.
SAP E-Book

Antwort: No Transports an TP Process in st atus END

Oh and don't forget to enter a * in the SM37 selection screen for the event
field when looking for these jobs ... 😎

You might also wanna stay out of STMS because I've seen it happen that STMS
auto-restarts the tp and recreates the problem infinitely until after doing
all the checks I mentioned and then doing manual tp import all's finally
well again?

Louis.


-----Original Message-----
From: Louis.ForeeZctacalign.com [mailto:Louis.ForeeZctacalign.com]
Sent: woensdag 22 januari 2003 17:02
To: DoNotReply@consolut.eu
Subject: RE: Antwort: RE: No Transports an TP Process in st
atus END


But have you checked for other "hanging" RDD* jobs? RDDIMPDP is but one of a
range that can be needed to run in R/3 background during tp import depending
on what objects are imported. Jobs like RDDVERSL, RDDEXECL and RDDMASSG (not
sure about spelling) can also hang!

Louis.


-----Original Message-----
From: thomas.kremminZseeber.de [mailto:thomas.kremminZseeber.de]
Sent: woensdag 22 januari 2003 16:59
To: DoNotReply@consolut.eu
Subject: Antwort: RE: No Transports an TP Process in status
END



Thank Louis,

This seem not to be the problem. The files TBATG, TRBAT, TRJOB are empty.
Tha last RDDIMPDP was runnig at 8 a clock this norming (ended normal)
If I start transaktion STMS a TP job is initialized in the substem. When I
finshed this session the TP-Job is always aktiv.
If you try to stop this job with option 4 (immed) this job goes to status
end but will never end so I stoped it with ENDJOBABN.

regards
Thomas


|---------+---------------------------->
| | Louis.ForeeZctaca|
| | lign.com |
| | |
| | 22.01.2003 16:23 |
| | Bitte antworten |
| | an SAP on System i |
|---------+---------------------------->

>---------------------------------------------------------------------------
---------------------------------------------------|
|
|
| An: DoNotReply@consolut.eu
|
| Kopie:
|
| Thema: RE: No Transports an TP Process in status
END |

>---------------------------------------------------------------------------
---------------------------------------------------|




From back in beginning of September last year when someone else had
problems
like these ... Louise Moloney suggested note 71353 ... and I suggested:
Check if RDDIMPDP jobs (general 1 and 1 per client) are scheduled properly
in the background ... I have seen it happen that the client-dependent 1 was
NOT properly scheduled and this only becomes problem during transport with
client-dependent matter in it ... either that or a previous transport
abended, leaving running tp or R3trans and in that case you will have to do
all the checks for a crashed tp as described in some chapter about error
handling in the upgrade docu ...

This last case means making sure no more tp's are running on the OS level,
stopping RDD* jobs that think they are running but aren't (SM37 check
status), clean-out TBATG, TRBAT and TRJOB, check and possibly remove
corresponding files from /usr/sap/trans/tmp and then try a first tp import
again and hopefully/normally all runs OK again ...

Hope this helps, Louis.


-----Original Message-----
From: thomas.kremminZseeber.de [mailto:thomas.kremminZseeber.de]
Sent: woensdag 22 januari 2003 16:09
To: DoNotReply@consolut.eu
Subject: No Transports an TP Process in status END


Hi group,

just a small problem for you.
There are no more transports going into our Q-system.
If you look at the system screen in STMS it looks like the transportsystem
is runnig.
But it is always on the same transport job.
A lot of TP jobs in WRKACTJOB in status end. They can only be ende with
ENDJOBABN.
In the TP-systemlog the last entry is from 8 a clock this morning.
In the TP monitor it tells me that 3 TP proccesses with 3 different
transports are runnig.
We restarted the system one time but nothing changed.

Every help is welcome.

Regards
Thomas


Have a look to our homepage at: http://www.consolut.net
DoNotReply@consolut.eu

Your use of consolut is subject to http://www.consolut.net



[Non-text portions of this message have been removed]


Y
a
h
o
o
!
G
r
o
u
p
s
S
p
o
n
s
o
r



A
D
V
E
R
T
I
S
E
M
E
N
T








Have a look to our homepage at: http://www.consolut.net
DoNotReply@consolut.eu





Have a look to our homepage at: http://www.consolut.net
DoNotReply@consolut.eu

Your use of consolut is subject to http://www.consolut.net



[Non-text portions of this message have been removed]



Have a look to our homepage at: http://www.consolut.net
DoNotReply@consolut.eu

Your use of consolut is subject to http://www.consolut.net



[Non-text portions of this message have been removed]


Durban Tours - Südafrika Safari

CPI1466 during Backup   RFUMSV00 - Advance Return for Tax on Sales/Purchases  
This documentation is copyright by SAP AG.

Length: 7880 Date: 20240425 Time: 064925     sap01-206 ( 4 ms )