Ansicht
Dokumentation

CPA57B2 - Selection signals used to call controller &24 not correct. (C R) ( OS/400 )

CPA57B2 - Selection signals used to call controller &24 not correct. (C R) ( OS/400 )

ROGBILLS - Synchronize billing plans   rdisp/max_wprun_time - Maximum work process run time  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA57B2
Selection signals used to call controller &24 not correct. (C R)

Message Long Text :

Cause . . . . . : The network could not complete the connection to the remote controller because of a selection sequence error or transmission error. The probable causes are:
-- A character in the telephone number is not valid.
-- The closed user group (CUG) index is not registered.
-- A non-abbreviated telephone number was used on a CUG call.
-- A local DCE problem.
-- A transmission error.
Recovery . . . : Do the following:
Verify that the connection number (CNNNBR parameter) in the controller description is correct.
Then do one of the following:
-- Type C to cancel recovery and to inform any applications that are waiting for an operation that the recovery has been canceled.
-- Type R to try the operation one more time.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel.
R -- Try again one more time.
Technical description . . . . . . . . : The error log identifier is &22.
The error code is &40. The error codes and their meanings are as follows:
44001822 -- The system received a call progress signal (CPS) 22 from the network during a calling sequence, indicating an invalid selection signal sequence was received by the network.

Message File : QCPFMSG
Library Message File : QSYS2924


Addresses (Business Address Services)   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3278 Date: 20240328 Time: 234449     sap01-206 ( 3 ms )