Ansicht
Dokumentation

CPA5803 - Line &23 not contacted. Internal system failure. (C N R) ( OS/400 )

CPA5803 - Line &23 not contacted. Internal system failure. (C N R) ( OS/400 )

BAL Application Log Documentation   rdisp/max_wprun_time - Maximum work process run time  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA5803
Line &23 not contacted. Internal system failure. (C N R)

Message Long Text :

Cause . . . . . : The system cannot establish contact with line &23. The network interface associated with the call is &30. The ISDN cause code associated with the call is &41 (&43 &44).
Recovery . . . : Reply to the message.
If the problem continues, do one or more of the following:
-- Use the Vary Configuration (VRYCFG) command to vary line &23 off, then on.
-- For lines that do not attach to a network interface, use the VRYCFG command to vary line &23 off. Then use the VRYCFG command with reset (RESET parameter) specified as yes (*YES) if allowed to reset the input/output processor (IOP) and to vary line &23 on. If the system sends a diagnostic message because other lines are varied on, vary them off, then vary line &23 on with the RESET parameter specified as *YES if allowed.
-- For lines that attach to a network interface, use the VRYCFG command to vary off the network interface the line was using. Then use the VRYCFG command with the RESET parameter specified as *YES if allowed to reset the IOP and to vary the network interface on.
-- Report the problem (ANZPRB command).
Possible choices for replying to message . . . . . . . . . . . . . . . :
R -- Try the operation one more time when line &23 is available.
C -- Cancel the dial attempt to the network. Any applications and subsystems that are waiting for an operation will be informed that the call has been canceled.
N -- Retry the dial operation to the network. Depending on values specified for the switched line list (SWTLINLST) and the switched line selection (SWTLINSLCT) parameters configured in each controller description, the system may choose a different line description to complete the call. The SWTLINSLCT parameter is only valid for X.25 configurations.
Technical description . . . . . . . . : The error code is &40: Internal system failure.
The ISDN cause information element is: &42.

Message File : QCPFMSG
Library Message File : QSYS2924


ABAP Short Reference   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3260 Date: 20240329 Time: 091147     sap01-206 ( 3 ms )