Ansicht
Dokumentation

CPC3A40 - Abnormal end of SNADS *SVDS receiver &3/&2/&1 using distribution queue &4. ( OS/400 )

ROGBILLS - Synchronize billing plans   BAL Application Log Documentation  
This documentation is copyright by IBM.


Message : CPC3A40
Abnormal end of SNADS *SVDS receiver &3/&2/&1 using distribution queue &4.

Message Long Text :

Cause . . . . . : The SNA distribution services (SNADS) job &3/&2/&1 detected an error while using distribution queue &4 and is ending abnormally. Reason code &5 indicates the cause of the error as defined in the list of reason codes below:
01 -- Distribution queue not configured
02 -- Communications connection is in use
03 -- Error while performing communications operation
04 -- Available memory remaining has reached the threshold value
05 -- Remote system sent bad data or violated protocol
06 -- Recoverable error while processing internal objects
07 -- Permanent error while processing internal objects
08 -- A distribution has been discovered damaged
09 -- Error while using communications device &6
10 -- Error while processing SNADS queues
11 -- Error while processing database file
12 -- Error while making a SNADS log entry
13 -- Error while attempting to start a new sender
99 -- Unknown error occurred
Recovery . . . :
01 -- Configure a distribution queue having either the connection ID associated with device &6 or the distribution queue name &4, depending on which is known.
02 -- Either another SNADS receiver is already using the connection or an operator is changing the SNADS configuration. Try again later.
03, 07, 09, 11, 12, 13, and 99 -- See the previously listed messages in the job log, correct any errors, and try the request again.
04 -- Because the receiver cannot receive the distribution, the receiver discards it and tells the remote sending function to send it again later. Use the System Services Tools function to display and change the threshold value, or use the Reclaim Storage (RCLSTG) command to reclaim storage on the receiving system. Then start the sending function again. See the Recovering your system book, SC41-5304, for more information on the System Service Tools.
05 -- The remote sender job is functioning incorrectly. Contact someone responsible for servicing the remote system.
06 and 08 -- Try the request again. These problems should correct themselves.
10 -- End the QSNADS subsystem (ENDSBS command) and then start the QSNADS subsystem (STRSBS command).

Message File : QCPFMSG
Library Message File : QSYS2924


BAL_S_LOG - Application Log: Log header data   SUBST_MERGE_LIST - merge external lists to one complete list with #if... logic for R3up  
This documentation is copyright by IBM.

Length: 3298 Date: 20240424 Time: 030812     sap01-206 ( 2 ms )