Ansicht
Dokumentation

CPCE00F - IPX circuit &1 added. Static routes and services required. ( OS/400 )

BAL Application Log Documentation   Vendor Master (General Section)  
This documentation is copyright by IBM.


Message : CPCE00F
IPX circuit &1 added. Static routes and services required.

Message Long Text :

Cause . . . . . : Circuit &1 was added to the IPX configuration. However, at least one static route must be configured because one of the following scenarios exists:
-- An X.25 Switch Virtual Circuit (SVC) on demand circuit was added.
-- A circuit that is not enabled for any type of routing, either NetWare Link Services Protocol (NLSP) or Routing Information Protocol (RIP), was added. This situation occurs when the IPX routing protocol (IPXRTGPCL) parameter on the IPX description is set to a value of *RIP and the RIP state (RIPSTATE) parameter on the circuit is set to a value of *OFF. It can also occur when the IPX routing protocol (IPXRTGPCL) parameter on the IPX descripton is set to a value of *NLSP and both the enable for NLSP (ENBNLSP) parameter and the RIP State (RIPSTATE) parameter on the circuit are set to a value of *OFF.
Recovery . . . : Before attempting to start the circuit, at least one static route must be configured for this circuit. Use the Add Circuit Route (ADDCCTRTE) CL command to add a static route.
Also, consider configuring at least one static service for this circuit. Use the Add Circuit Service (ADDCCTSRV) CL command to add a static service.

Message File : QCPFMSG
Library Message File : QSYS2924


CPI1466 during Backup   CPI1466 during Backup  
This documentation is copyright by IBM.

Length: 3246 Date: 20240420 Time: 035451     sap01-206 ( 2 ms )