Ansicht
Dokumentation

CPD316A - Constraints may not have duplicated correctly for file &1 in &3. ( OS/400 )

Vendor Master (General Section)   Fill RESBD Structure from EBP Component Structure  
This documentation is copyright by IBM.


Message : CPD316A
Constraints may not have duplicated correctly for file &1 in &3.

Message Long Text :

Cause . . . . . : Errors may have occurred adding constraints to file &1 in library &3. Constraints may not have been added or may have been added and put into a different state (defined instead of established or disabled instead of enabled). Use the DSPFD (Display File Description) command to view the constraint information for both the original file &5 in library &4 and the duplicated file &1 in library &3.
Recovery . . . : See previous messages for constraints that were not added. If the constraints do not exist, add the constraints using the Add Physical File Constraint (ADDPFCST) command. If the constraints exist and the state is different than the state in the file that was duplicated, do one of the following:
If the constraint is in the disabled state in the duplicate file
and the constraint was in the enabled state in the original file,
use the CHGPFCST (Change Physical File Cosntraint) command to
enable the constraint.
If the constraint is in the defined state in the duplicate file
and the constraint was in the established state in the original
file, do one of the following:
Use the RMVPFCST (Remove Physical File Constraint) command
to remove the constraint and then use the ADDPFCST (Add
Physical File Constraint) command to add the constraint again.
Use the RMVM (Remove Member) command to remove the member and
then use the ADDPFM (Add Physical File Member) command to add the
member again

Message File : QCPFMSG
Library Message File : QSYS2924


Fill RESBD Structure from EBP Component Structure   CL_GUI_FRONTEND_SERVICES - Frontend Services  
This documentation is copyright by IBM.

Length: 3272 Date: 20240419 Time: 160850     sap01-206 ( 2 ms )