Ansicht
Dokumentation

CPDB157 - Device &25 configuration not valid. Reason code &1. ( OS/400 )

CPDB157 - Device &25 configuration not valid. Reason code &1. ( OS/400 )

CPI1466 during Backup   ABAP Short Reference  
This documentation is copyright by IBM.
SAP E-Book


Message : CPDB157
Device &25 configuration not valid. Reason code &1.

Message Long Text :

Cause . . . . . : The vary configuration (VRYCFG) command failed. Reason codes and their meanings follow:
--2309: The APPN device &25 can not be varied on because allow virtual APPN support (ALWVRTAPPN) parameter was enabled in the network attributes when the attached controller was varied on.
--2320: The device &25 can not be varied on because the associated Ethernet line description specifies a hardware resource (RSRCNAME) parameter that only supports TCP/IP.
--2321: The local internet address (LCLINTNETA) provided for device &25 could not be converted to a binary address.
--2322: The LCLINTNETA provided for device &25 is not defined.
--2323: The LCLINTNETA provided for device &25 is in an unrecoverable error state.
--2324: There is another tape library description already varied on for this 3494, however it is not using the same LCLINTNETA as specified for device &25.
Recovery . . . :
Reason codes and their meanings follow. Do one of the following and then try the request again:
--2309, do one of the following:
If you do not want to use virtual APPN support, vary off the attached controller, change the allow virtual APPN support (ALWVRTAPPN) parameter in the network attributes, then vary the controller back on. The APPN device can now be varied on. This will affect all APPN communications being done by the system.
If you want to use virtual APPN support, you may delete this device description since it is no longer used. The system will automatically create a new APPN device description for you under an APPN virtual controller.
If you are enabling and disabling virtual APPN support for testing purposes, you can ignore this error.
--2320: Using the Work With Configuration Status (WRKCFGSTS) command, locate or create a device description associated with an Ethernet line description that supports communication protocols in addition to TCP/IP.
--2321: Change the local internet address (LCLINTNETA) to be of the form ddd.ddd.ddd.ddd where ddd is a decimal number from 0-255.
--2322: Use the Work with TCP/IP interfaces option on the CFGTCP menu to determine the correct TCP/IP interface to use or to add the TCP/IP interface you wish to use.
--2323: Use the Work with TCP/IP interfaces option on the CFGTCP menu to determine why the interface is in a failed state.
--2324: Insure all tape library descriptions connecting to the same 3494 tape library are configured to use the same LCLINTNETA.

Message File : QCPFMSG
Library Message File : QSYS2924


Vendor Master (General Section)   SUBST_MERGE_LIST - merge external lists to one complete list with #if... logic for R3up  
This documentation is copyright by IBM.

Length: 3265 Date: 20240329 Time: 014710     sap01-206 ( 3 ms )