Ansicht
Dokumentation

CPF0921 - Start Prestart Jobs command not allowed now. ( OS/400 )

CPF0921 - Start Prestart Jobs command not allowed now. ( OS/400 )

General Material Data   Vendor Master (General Section)  
This documentation is copyright by IBM.
SAP E-Book


Message : CPF0921
Start Prestart Jobs command not allowed now.

Message Long Text :

Cause . . . . . : The Start Prestart Jobs (STRPJ) command is not allowed at this time for reason &4. See reason &4 shown below:
1 - The prestart jobs for program &1 in library &2 in subsystem &3 are already active.
2 - The prestart jobs for program &1 in library &2 in subsystem &3 are ending.
3 - Subsystem &3 is not active. The subsystem must be active when the STRPJ command is used.
4 - Subsystem &3 is ending.
5 - Subsystem &3 is in the restricted condition.
Recovery . . . : The recovery for reason &4 is procedure &4:
1 - No action is needed.
2 - Wait for the prestart jobs for program &1 in library &2 in subsystem &3 to end, or use the End Prestart Job (ENDPJ) command with the OPTION parameter specified as *IMMED for program &1 in library &2 in subsystem &3. When the prestart jobs have ended (message CPC0905 is sent to the system operator message queue), use the STRPJ command again.
3 - Start subsystem &3 using the Start Subsystem (STRSBS) command. Then use the STRPJ command again if the prestart jobs are not automatically started by the subsystem.
4 - Wait for subsystem &3 to end. After subsystem &3 has ended, use the STRSBS command. Then use the STRPJ command again if the prestart jobs are not automatically started by the subsystem.
5 - Start subsystem &3 by using the Start Subsystem (STRSBS) command. Then use the STRPJ command again if the prestart jobs are not automatically started by the subsystem.

Message File : QCPFMSG
Library Message File : QSYS2924


PERFORM Short Reference   rdisp/max_wprun_time - Maximum work process run time  
This documentation is copyright by IBM.

Length: 3246 Date: 20240329 Time: 140217     sap01-206 ( 2 ms )