Ansicht
Dokumentation
CPF1BBE - No dial tone after pause. ( OS/400 )
TXBHW - Original Tax Base Amount in Local Currency PERFORM Short ReferenceThis documentation is copyright by IBM.
Message : CPF1BBE
No dial tone after pause.
Message Long Text :
Cause . . . . . : The DCE waited after a dialing pause for a dial tone but did not sense one. Possible causes are:
-- The telephone number specified in the TELNBR parameter is not correct.
-- The telephone network did not supply a dial tone where the pause character (,) was entered in the TELNBR parameter.
Recovery . . . : Do the following and try the request again:
-- Check that the telephone number specified in the TELNBR parameter is correct, including the position of the pause character (,).
-- If a pause is not needed, omit the pause character (,) from the TELNBR parameter.
-- If the telephone network does not supply a dial tone where a pause is needed, reconfigure the DCE to pause for a fixed time without waiting for a dial tone. (See your DCE documentation for details on pausing within the telephone number.)
Technical description . . . . . . . . : The sense byte error code is &1.
Message File : QCPFMSG
Library Message File : QSYS2924
Vendor Master (General Section) TXBHW - Original Tax Base Amount in Local Currency
This documentation is copyright by IBM.
Length: 3219 Date: 20240424 Time: 105415 sap01-206 ( 2 ms )