Ansicht
Dokumentation

CPF594E - Mode &1 specified for remote location &3 currently not available. ( OS/400 )

Vendor Master (General Section)   SUBST_MERGE_LIST - merge external lists to one complete list with #if... logic for R3up  
This documentation is copyright by IBM.


Message : CPF594E
Mode &1 specified for remote location &3 currently not available.

Message Long Text :

Cause . . . . . : Device &5 with remote location &3, local location &2, and remote network identifier &4 attempted to use mode &1, which is currently not available. Mode &1 cannot be used because it would cause the maximum number of conversations for the location to be exceeded by &6 conversations.
Recovery . . . : Do one of the following:
-- Use the Change Mode Description (CHGMODD) command to lower the conversation limit for mode &1, then try the request again. Using the Vary Configuration (VRYCFG) command, vary off all device descriptions that have the same remote location name (RMTLOCNAME parameter) and local location name (LCLLOCNAME parameter) as device &5. When all the device descriptions have varied off, try the request again.
Allow the system support to vary the device descriptions back on.

Message File : QCPFMSG
Library Message File : QSYS2924


General Material Data   PERFORM Short Reference  
This documentation is copyright by IBM.

Length: 3251 Date: 20240425 Time: 150856     sap01-206 ( 3 ms )