Ansicht
Dokumentation

CPF6B82 - Dial not initiated for controller &7. No lines available. ( OS/400 )

CPF6B82 - Dial not initiated for controller &7. No lines available. ( OS/400 )

rdisp/max_wprun_time - Maximum work process run time   Vendor Master (General Section)  
This documentation is copyright by IBM.
SAP E-Book


Message : CPF6B82
Dial not initiated for controller &7. No lines available.

Message Long Text :

Cause . . . . . : The system is attempting to dial out to the controller, but the lines specified in the line list (LINLST parameter) are not available for one of the following reasons:
-- All the specified lines are varied on and have the maximum number of sessions running.
-- One or more of the specified lines is varied off.
-- One or more of the specified lines is pending recovery from a previous communications failure.
-- The DFTPKTSIZE parameter of the controller description is greater than the MAXPKTSIZE parameter of the network description.
Recovery . . . : Do one of the following:
-- End one or more of the sessions currently running on one of the specified lines.
-- Vary on one of the lines listed in the LINLST parameter (VRYCFG command)
-- See the previously listed messages in the job log for information about the previous communications failure.
-- Verify that the values specified for the DFTPKTSIZE and MAXPKTSIZE parameters are valid.
Technical description . . . . . . . . : MODCD(Dial) failed with MCH5204.

Message File : QCPFMSG
Library Message File : QSYS2924


PERFORM Short Reference   ROGBILLS - Synchronize billing plans  
This documentation is copyright by IBM.

Length: 3258 Date: 20240328 Time: 172258     sap01-206 ( 2 ms )