Ansicht
Dokumentation
CPI5793 - Network interface &30 failed. No response from NT. ( OS/400 )
General Data in Customer Master SUBST_MERGE_LIST - merge external lists to one complete list with #if... logic for R3upThis documentation is copyright by IBM.
Message : CPI5793
Network interface &30 failed. No response from NT.
Message Long Text :
Cause . . . . . : The following may have caused the problem: The ISDN physical interface (NT) could not be activated. One possible problem is that the values specified for the activation timers for network interface &30 are too small.
Recovery . . . : Use the Vary Configuration (VRYCFG) command to vary network interface &30 off, then on.
If the problem continues, use the VRYCFG command to vary network interface &30 off, then use the VRYCFG command with reset (RESET parameter) specified as yes (*YES) if allowed to reset the input/output processor (IOP) and to vary network interface &30 on. If the system sends a diagnostic message because other network interfaces are varied on, vary them off, then vary network interface &30 on with the RESET parameter specified as *YES if allowed.
If the problem continues, press F14 to run problem analysis.
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40: ISDN physical interface did not activate.
Message File : QCPFMSG
Library Message File : QSYS2924
SUBST_MERGE_LIST - merge external lists to one complete list with #if... logic for R3up General Material Data
This documentation is copyright by IBM.
Length: 3239 Date: 20240420 Time: 073400 sap01-206 ( 3 ms )