Ansicht
Dokumentation

CPI590A - Line &23 failed. Configuration error or internal system failure. ( OS/400 )

CPI590A - Line &23 failed. Configuration error or internal system failure. ( OS/400 )

Vendor Master (General Section)   RFUMSV00 - Advance Return for Tax on Sales/Purchases  
This documentation is copyright by IBM.
SAP E-Book


Message : CPI590A
Line &23 failed. Configuration error or internal system failure.

Message Long Text :

Cause . . . . . : If the line protocol is asynchronous, the following may have caused the problem:
--- The line configuration may not be the same as the configuration of the remote device.
--- The end of record characters may be too close together in the data stream.
--- An internal system failure may have occurred.
If the line protocol is not asynchronous, an internal system failure occurred.
Recovery . . . : Do one or more of the following:
If the line protocol is asynchronous:
-- Verify that the configuration parameters are the same as those of the remote device, particularly the line speed (LINESPEED parameter), echo (ECHO parameter), and parity (PARITY parameter) values in the Create Asynchronous Line Description (CRTLINASC) command.
-- Use the communications trace function of the Start System Service Tool (STRSST) command to examine the data stream to determine if the end of record characters are too close. If they are, you may not be able to use end of record processing. Change the end of record table (EORTBL parameter) value in line description &23 to indicate that no end of record table be used.
-- Use the Vary Configuration (VRYCFG) command to vary line &23 off, then on.
-- Use the VRYCFG command to vary line &23 off. Then use the VRYCFG command with reset (RESET parameter) specified as yes (*YES) if allowed to reset the input/output processor (IOP) and to vary line &23 on.
If the system sends a diagnostic message because other lines are varied on, vary them off, then vary line &23 on with the RESET parameter specified as *YES if allowed then vary the other lines on.
If the problem continues, report the problem (ANZPRB command).
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40:

Message File : QCPFMSG
Library Message File : QSYS2924


TXBHW - Original Tax Base Amount in Local Currency   PERFORM Short Reference  
This documentation is copyright by IBM.

Length: 3270 Date: 20240329 Time: 073151     sap01-206 ( 3 ms )