Ansicht
Dokumentation

CPI594E - Call from controller on line &23 not accepted. ( OS/400 )

Fill RESBD Structure from EBP Component Structure   General Data in Customer Master  
This documentation is copyright by IBM.


Message : CPI594E
Call from controller on line &23 not accepted.

Message Long Text :

Cause . . . . . : The identification procedure between the local system and the remote system failed because there is:
-- a local system configuration problem, or
-- a remote system configuration problem, or
-- a remote system failure.
The local system cannot identify the remote system.
Recovery . . . : Do one or more of the following:
-- Use the Display Line Description (DSPLIND) command to display the exchange identifier (EXCHID parameter) of line description &23. Verify that this is the exchange identifier the remote system expects the local system to send. If it is not, either change the remote system configuration, or use the Delete Line Description (DLTLIND) command and the appropriate create line description command to delete and and create line description &23 again using the correct EXCHID parameter.
-- Use the Display Network Attributes (DSPNETA) command to display the local control point name (LCLCPNAME parameter) of the network attributes. Verify that this is the control point name the remote system expects the local system to send. If it is not, either change the remote system configuration, or use the CHGNETA command to change the LCLCPNAME parameter.
-- Use the DSPNETA command to display the local network identifier (LCLNETID parameter) of the network attributes. Verify that this is the network identifier the remote system expects the local system to send. If it is not, either change the remote system configuration, or use the CHGNETA command to change the LCLNETID parameter.
-- Ask the remote system operator to determine whether or not there is a problem at the remote system.
When the problem is corrected, tell the remote system operator to try the call again.
If the problem continues, report the problem (ANZPRB command).
Technical description . . . . . . . . : The error code is &40: The controller sent exchange identifier (XID) &41, which contains control vector X'22'.
For more information on XIDs, see Systems Network Architecture Formats, GA27-3136.

Message File : QCPFMSG
Library Message File : QSYS2924


Addresses (Business Address Services)   General Data in Customer Master  
This documentation is copyright by IBM.

Length: 3252 Date: 20240425 Time: 131225     sap01-206 ( 2 ms )