Ansicht
Dokumentation
CPI7E57 - Ethernet line &23 failed. ( OS/400 )
Fill RESBD Structure from EBP Component Structure CL_GUI_FRONTEND_SERVICES - Frontend ServicesThis documentation is copyright by IBM.
Message : CPI7E57
Ethernet line &23 failed.
Message Long Text :
Cause . . . . . : The following may have caused the problem:
-- Network termination, cabling or network devices.
-- DUPLEX value for line &23 does not match network device (router, hub or switch) port's duplex value.
-- LINESPEED value for line &23 does not match network device (router, hub or switch) port's line speed.
Recovery . . . :
-- Check the Ethernet cabling for a loose connection or cable damage.
-- Verify that both duplex value and line speed are set the same for the line description and the network device (router, hub or switch) port. If the port in the network device is configured to auto-negotiate, then the duplex and line speed configuration needs to match the port configuration.
-- If any cabling or configuration problems were found and corrected, reply to any unanswered messages in the QSYSOPR message queue, (vary off/on the Ethernet line if necessary), and retry the procedure that failed.
-- If no cabling/configuration problems were found, press F14 to report the problem to your hardware service provider.
Technical description . . . . . . . . : The Ethernet adapter detected excessive collisions on the network.
- Problem Log ID ........: &35
- Processor Resource ....: &26
- Adapter Resource ......: &27
- Port Resource .........: &28
Message File : QCPFMSG
Library Message File : QSYS2924
TXBHW - Original Tax Base Amount in Local Currency ROGBILLS - Synchronize billing plans
This documentation is copyright by IBM.
Length: 3233 Date: 20240425 Time: 135850 sap01-206 ( 2 ms )