Ansicht
Dokumentation

CPI8816 - Recovery failed for SNADS sender &3/&2/&1, serving *SNADS distribution queue &5 ( OS/400 )

Addresses (Business Address Services)   PERFORM Short Reference  
This documentation is copyright by IBM.


Message : CPI8816
Recovery failed for SNADS sender &3/&2/&1, serving *SNADS distribution queue &5

Message Long Text :

Cause . . . . . : The SNADS sender is unable to send distribution queue entries due to reason code &4. The number of consecutive failures has exceeded the retry limit (&7) configured for this queue. The reason codes and their meanings follow:
21 -- A communications session was not available
22 -- Communications failed or could not be established with the remote system
23 -- The remote system detected a recoverable distribution error and ended communications
24 -- The remote system detected an irrecoverable distribution error and ended communications. The distribution was deleted
25 -- A recoverable error occurred while accessing distribution data
26 -- An irrecoverable error occurred while accessing distribution data. The distribution was deleted
27 -- Damage was encountered while processing a distribution. The distribution was lost
Recovery . . . : The reason codes and their recovery actions follow:
21, 22, 25 and 26 -- See the previously listed messages in the job log, and correct any errors.
23 -- Determine the cause of the problem on the remote system, and correct the problem on the remote system. The distribution log contains additional information reported by the remote system. (This error often results when the remote system does not have enough storage available to receive the distribution.)
24 -- This error may be the result of a failure on either the sending or receiving system. An entry has been created in the problem log. Use the WRKPRB command to report the problem. The distribution log contains additional information reported by the remote system.
27 -- No recovery action is possible.
For all recovery actions, start the sender again by doing one of the following:
-- Send the entries on the queue (SNDDSTQ command or option 2 from the WRKDSTQ display).
-- Hold and release the queue (HLDDSTQ and RLSDSTQ commands or options 3 and 6 from the WRKDSTQ display) to ready the queue for normal sending.
Technical description . . . . . . . . : The failing sender is automatically started whenever: the QSNADS subsystem is started, a start or force time occurs for the queue, or a receiver starts for a queue that has the send while receiving option configured.

Message File : QCPFMSG
Library Message File : QSYS2924


rdisp/max_wprun_time - Maximum work process run time   ROGBILLS - Synchronize billing plans  
This documentation is copyright by IBM.

Length: 3291 Date: 20240425 Time: 223117     sap01-206 ( 3 ms )