Ansicht
Dokumentation

CPI8F5F - Line &23 threshold information. ( OS/400 )

General Material Data   ABAP Short Reference  
This documentation is copyright by IBM.


Message : CPI8F5F
Line &23 threshold information.

Message Long Text :

Cause . . . . . : One of the following may have caused the problem:
-- The line speeds too high.
-- There may be too many lines attached to the same communications controller card.
-- The communications subsystem may be overloaded.
-- Too many service functions may be are being done on the communications subsystem.
Recovery . . . : You may choose to ignore this message because your line is operational. If you are not satisfied with the operation of your communications equipment, reduce the line speeds or the number of lines. Reduce your communications work load by turning off lines or by ending service functions that are not needed. To determine which lines are active and use the same communications controller card, you may choose to vary off the line and vary it on using the vary configuration (VRYCFG) command with RESET(*YES) specified. The VRYCFG command will display a message for each active line. Then you may choose to vary off these lines and vary on the line in error to reset this line. This will cause the program to be loaded again. The threshold function may be turned off or changed in the threshold (THRESHOLD) parameter on the CRTLINX25 command. To report the problem, start problem analysis (ANZPRB command).
Technical description . . . . . . . . : The counter for hardware underrun errors reached the value specified by the THRESHOLD value in the CRTLINSDLC command.

- Processor Resource ....: &26
- Adapter Resource ......: &27
- Port Resource .........: &28

Message File : QCPFMSG
Library Message File : QSYS2924


CPI1466 during Backup   General Data in Customer Master  
This documentation is copyright by IBM.

Length: 3231 Date: 20240419 Time: 143915     sap01-206 ( 4 ms )