Ansicht
Dokumentation

CPPC040 - Ethernet line &23 failed. ( OS/400 )

PERFORM Short Reference   General Material Data  
This documentation is copyright by IBM.


Message : CPPC040
Ethernet line &23 failed.

Message Long Text :

Cause . . . . . : One of the following may have caused the problem:
-- The Ethernet external cable.
-- DUPLEX value for line &23 does not match network device (router, hub or switch) port's duplex value.
-- LINESPEED value for line &23 does not match network device (router, hub or switch) port's line speed.
-- Network termination, the network or network devices.
-- The Ethernet adapter card.
Recovery . . . :
-- Make sure the Ethernet cable is attached to the Ethernet adapter card and a network device, and reseat the cable connectors.
-- Check the network device (router, hub or switch) ports for lights, and reset if necessary. Verify that the network device has not lost power.
-- Verify that both duplex value and line speed are set the same for the line description and the network device (router, hub or switch) port.
-- Check the Ethernet cable for physical damage. If the cable type is UTP (unshielded twisted pair), make sure the cable is wired according to the EIA/TIA-568A standard:
Pins 1 and 2 using the same twisted pair,
Pins 3 and 6 using the same twisted pair,
Pins 4 and 5 using the same twisted pair,
Pins 7 and 8 using the same twisted pair.
-- If any cabling or configuration problems were found and corrected, reply to any unanswered messages in the QSYSOPR message queue, (vary off/on the Ethernet line if necessary), and retry the procedure that failed.
-- If no cabling/configuration problems were found, press F14 to report the problem to your hardware service provider.

Technical description . . . . . . . . :
To determine if the Ethernet adapter card is defective, perform the hardware verification test, as indicated below:
First, determine the port hardware resource name using the Display Line Description command for line &23 (DSPLIND &23 ). Once you have determined the resource name, start System Service Tools (STRSST), then select Start a service tool, Hardware Service Manager, Locate Resource by Resource name. Enter the port hardware resource name and then select the Verify option, and run all tests. If all tests pass, do not replace the adapter card.

- Problem Log ID ........: &35
- Processor Resource ....: &26
- Adapter Resource ......: &27

Message File : QCPFMSG
Library Message File : QSYS2924


General Material Data   Addresses (Business Address Services)  
This documentation is copyright by IBM.

Length: 3253 Date: 20240420 Time: 122450     sap01-206 ( 2 ms )