Ansicht
Dokumentation

00567 - Installing a 3.1H system on a box with a 4.5B system

00567 - Installing a 3.1H system on a box with a 4.5B system

rdisp/max_wprun_time - Maximum work process run time   PERFORM Short Reference  
This documentation is copyright by SAP AG.
SAP E-Book

Installing a 3.1H system on a box with a 4.5B system


Hi Greg,
One more point; you don't need to rename the debug library. Leave it at the
default. This library was used for diagnostic purposes by IBM and SAP in
the 3.1X releases. It is not part of the 4.XX installs and is no longer
needed in the later releases. The 3.1X install will still install it but,
if you leave it at the default only one debug library will be installed and
that is all you need.

Cheers,
Steve Boucher



Steven Boucher/Los Angeles/IBMZIBMUSZIBMUS on 01/31/2001 08:13:40 AM

To: gnelsonZw...
cc: sap400Zm...
Subject: Re: Installing a 3.1H system on a box with a 4.5B system




Hi Greg

Changing the kernel (optimized) and debug library names during the install
is quite common. By changing the library name you can install separate
kernel libraries for each SID installed on an AS/400. Separate kernel
libraries allow you to do kernel upgrades to one SID without disrupting
another SID. It increases your flexibility in the future. If you are
installing only one SID on a system, it is not necessary to rename the
library but, you might want to consider it for consistency with the naming
on your other systems.

Typical names would be something like R3<SID><rel> where SID=the name of
your SID and rel=the R/3 release of the kernel.

Cheers,
Steve Boucher



gnelsonZw... on 01/31/2001 05:42:33 AM

To: sap400Zm...
cc:
Subject: Installing a 3.1H system on a box with a 4.5B system



Hello to all!
We are attempting to restore our 3.1H system on an AS/400 box that already
has an existing 4.5B system residing on it.
When reading the installation manual for 3.1H, there is a section called
"Installing additional R/3 systems." In that section, the manual says, in
option 1 "Work with R/3 Systems," then option 1, "Add R/3 System," to
"replace the *DEFAULT entries for your optomized and debug libraries with
the names you have decided on." My question is has anyone done before? If
so, what names are appropriate for this?
Any information on this type of install is greatly appreciated!
Thank you in advance!
Greg









Durban Tours - Südafrika Safari

rdisp/max_wprun_time - Maximum work process run time   BAL_S_LOG - Application Log: Log header data  
This documentation is copyright by SAP AG.

Length: 3176 Date: 20240328 Time: 181233     sap01-206 ( 2 ms )