We are hiring and constantly growing! Have a look through our vacancies to find the right role for you!

CPA5763 - Controller &24 on line &23 not contacted. Configuration problem. (C G R) ( OS/400 )

CPA5763 - Controller &24 on line &23 not contacted. Configuration problem. (C G R) ( OS/400 )

PERFORM Short Reference   Fill RESBD Structure from EBP Component Structure  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA5763
Controller &24 on line &23 not contacted. Configuration problem. (C G R)

Message Long Text :

Cause . . . . . : Either the local and remote systems have specified the same network identifier and control point name, or the received network identifier or control point name does not agree with the one in the controller description.
Recovery . . . : Contact the remote system operator to verify what the network identifier and the control point names should be.
If either are not correct, do the following:
All controller descriptions configured as advanced peer-to-peer networking (APPN parameter) must be varied off using the Vary Configuration (VRYCFG) command.
Then, use the Change Network Attributes (CHGNETA) command to correct the local control point name (LCLCPNAME parameter), the local network identifier (LCLNETID parameter), or both.
Then do one of the following:
-- Type C to cancel recovery and to inform any applications that are waiting for an operation that the recovery has been canceled.
-- Type R to try the operation one more time. If the problem continues, do the following:
Use the appropriate change controller description command to correct either the remote network identifier (RMTNETID parameter), or the remote control point name (RMTCPNAME parameter), or both in the controller description.
If the problem continues, report the problem (ANZPRB command).
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel.
G -- Start automatic recovery again.
R -- Try again one more time.
Technical description . . . . . . . . : The error log identifier is &22. The exchange identifier (XID) is &41.
The error code is &40. The error codes and their meanings follow:
CCCC000C -- The transmission group number negotiation failed because the network identifiers and the control point names are equal.
CCCC0018 -- The received XID does not contain a valid network identifier or control point name. This may indicate either a network identifier or a control point name was not present in the received XID.
For more information on XIDs, see Systems Network Architecture Formats, GA27-3136.

Message File : QCPFMSG
Library Message File : QSYS2924


ABAP Short Reference   Addresses (Business Address Services)  
This documentation is copyright by IBM.

Length: 3288 Date: 20201022 Time: 145441     sap01-206 ( 2 ms )