We are hiring and constantly growing! Have a look through our vacancies to find the right role for you!

CPA5775 - Call on line &23 failed, semi-permanent connection not supported by the network (C N R). ( OS/400 )

CPA5775 - Call on line &23 failed, semi-permanent connection not supported by the network (C N R). ( OS/400 )

Addresses (Business Address Services)   Addresses (Business Address Services)  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA5775
Call on line &23 failed, semi-permanent connection not supported by the network (C N R).

Message Long Text :

Cause . . . . . : The system cannot establish contact with line &23 over network interface &30 because a semi-permanent connection was requested, but the network identified in the network type (NETTYPE) parameter of the network interface does not support semi-permanent connections. Currently, only the Deutsche Bundespost (*DBP1TR6) supports semi-permanent connections. The ISDN cause code associated with the call is &41 (&43 &44).
Recovery . . . : Do one of the following:
-- Use the Work with Connection List Entry (WRKCNNLE) command to change the connection type (CNN) parameter of connection list entry &46, in connection list &45, to use a circuit-switched (*CIRCUIT) rather than a semi-permanent (*SEMIPERM) connection.
-- Use the Work with Network Interface Description (WRKNWID) command to ensure that the value specified for the NETTYPE parameter is correct.
Reply to the message.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
R -- Try the dial operation to the remote ISDN system again using line &23.
C -- Cancel the dial attempt to the remote ISDN system. Any applications and subsystems that are waiting for an operation will be informed that the call has been canceled.
N -- Retry the dial attempt to the remote ISDN system. Depending on the values specified for the switched line list (SWTLINLST) and the switched line selection (SWTLINSLCT) parameters configured in each controller description, the system may choose a different line description to complete the call. The SWTLINSLCT parameter is only valid for X.25 configurations.
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40:
The ISDN cause information element is: &42.

Message File : QCPFMSG
Library Message File : QSYS2924


TXBHW - Original Tax Base Amount in Local Currency   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3290 Date: 20201020 Time: 194511     sap01-206 ( 3 ms )