We are hiring and constantly growing! Have a look through our vacancies to find the right role for you!

CPA580E - Controller &24 not contacted. Probable configuration problem. (C R) ( OS/400 )

CPA580E - Controller &24 not contacted. Probable configuration problem. (C R) ( OS/400 )

Vendor Master (General Section)   BAL_S_LOG - Application Log: Log header data  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA580E
Controller &24 not contacted. Probable configuration problem. (C R)

Message Long Text :

Cause . . . . . : The probable causes are:
-- The local system has a communications configuration problem.
-- The remote system has a communications configuration problem.
-- A remote system failure.
Recovery . . . : Do one or more of the following:
-- Use the Work With Controller Description (WRKCTLD) and the Work With Line Description (WRKLIND) commands to verify that the exchange identifier is configured correctly on the local system. If &24 is a HOST controller the exchange identifier is configured in the controller description (LCLEXCHID parameter). Otherwise the exchange identifier is configured in line description &23 (EXCHID parameter).
-- Use the Display Network Attributes (DSPNETA) command to verify that the local control point name (LCLCPNAME parameter) of the network attributes is correct.
-- Use the Display Controller Description (DSPCTLD) command to verify the connection number (CNNNBR parameter).
-- If the connection type (CNN parameter) of the line description is *SHM, ask the remote system operator to verify that the remote system is configured for X.21 SHM.
-- Ask the remote system operator to verify that the exchange identifier (XID) and control point name are configured correctly on the remote system.
-- Ask the remote system operator to determine if there is any problem at the remote system that could cause this failure.
If the problem continues, press F14 to run problem analysis.
To increase the maximum number of remote systems that can use the line at the same time, use the appropriate change line description command to change the maximum number of controllers (MAXCTL parameter).
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel recovery and inform any applications that are waiting for an operation that the recovery has been canceled.
R -- Try again one more time.
Technical description . . . . . . . . : The XID is &41. The error code is &40: The received XID contains an XID negotiable error control vector. This problem is applicable only for a T2.1 node.

Message File : QCPFMSG
Library Message File : QSYS2924


Vendor Master (General Section)   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3279 Date: 20201028 Time: 060719     sap01-206 ( 4 ms )