Ansicht
Dokumentation

CPA58B6 - Call on line &23 failed. Time-out occurred. (C N R) ( OS/400 )

CPA58B6 - Call on line &23 failed. Time-out occurred. (C N R) ( OS/400 )

Vendor Master (General Section)   Vendor Master (General Section)  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA58B6
Call on line &23 failed. Time-out occurred. (C N R)

Message Long Text :

Cause . . . . . : A time-out occurred while attempting to call on line &23. The call was not completed within the time limit of the remote answer timer (RMTANSTMR parameter) specified in the line description. The probable causes for this failure are:
-- The X.25 packet switching network is not answering or the wrong number is being called.
-- The telephone line is not operational or is not connected to a modem.
-- A local hardware problem.
-- The remote answer timer (RMTANSTMR parameter) in the line description is set too low.
Recovery . . . : Do the following:
-- Verify that the X.25 packet switching network is operational and the connection number (CNNNBR parameter) in the line description is correct.
-- Verify that the telephone line is operational and is connected to the modem.
-- Verify that the remote answer timer (RMTANSTMR parameter) in the line description allows sufficient time for the call to complete.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel the dial attempt to the X.25 network and all logical calls waiting for the connection. Any applications and subsystems that are waiting for an operation will be informed that the logical call has been canceled.
N -- Cancel the dial operation to the X.25 network using line &23 and attempt to complete the pending logical calls. Depending on values specified for the switched line list (SWTLINLST) and the switched line selection (SWTLINSLCT) parameters configured in each controller description, the system may choose a different line description to complete the call.
R -- Try the operation one more time when line &23 is available.
Technical description . . . . . . . . : The error log identifier is &22.
The error code is &40: V.25bis call failure. The system did not detect data set ready (DSR) within the configured time limit.

Message File : QCPFMSG
Library Message File : QSYS2924


ABAP Short Reference   CL_GUI_FRONTEND_SERVICES - Frontend Services  
This documentation is copyright by IBM.

Length: 3263 Date: 20240328 Time: 143233     sap01-206 ( 3 ms )