Ansicht
Dokumentation

CPA58EB - Line &23 contact not successful on network interface &30. Potential cabling problem. (C N R) ( OS/400 )

CPA58EB - Line &23 contact not successful on network interface &30. Potential cabling problem. (C N R) ( OS/400 )

rdisp/max_wprun_time - Maximum work process run time   CL_GUI_FRONTEND_SERVICES - Frontend Services  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA58EB
Line &23 contact not successful on network interface &30. Potential cabling problem. (C N R)

Message Long Text :

Cause . . . . . : The outgoing call for line &23 on network interface &30 cannot be completed because the local system has detected a loss of signal. The probable causes are:
-- A network or external devices problem.
-- A cabling problem.
-- The network type (NETTYPE) parameter is not set correctly in network interface &30.
Recovery . . . : Do one or more of the following:
-- Verify that the network and external devices are operational.
-- Ensure that the local system is properly cabled to the network.
-- Use the Work with Network Interface Description (WRKNWID) command to ensure that the value specified for the NETTYPE parameter is correct.
Reply to the message.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
R -- Try the dial operation to the remote ISDN system again using line &23.
C -- Cancel the dial attempt to the remote ISDN system. Any applications and subsystems that are waiting for an operation will be informed that the call has been canceled.
N -- Retry the dial attempt to the remote ISDN system. Depending on the values specified for the switched line list (SWTLINLST) and the switched line selection (SWTLINSLCT) parameters configured in each controller description, the system may choose a different line description to complete the call. The SWTLINSLCT parameter is only valid for X.25 configurations.
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40, and has the following meaning:
44001F07 - Power source 1 (PS1) was not detected.
44001F08 - Layer 1 synchronization procedures were not successful.

Message File : QCPFMSG
Library Message File : QSYS2924


rdisp/max_wprun_time - Maximum work process run time   Addresses (Business Address Services)  
This documentation is copyright by IBM.

Length: 3304 Date: 20240328 Time: 104955     sap01-206 ( 2 ms )