We are hiring and constantly growing! Have a look through our vacancies to find the right role for you!

CPA58FC - Controller &24 not contacted, connect retry limit reached. (C G R) ( OS/400 )

CPA58FC - Controller &24 not contacted, connect retry limit reached. (C G R) ( OS/400 )

CPI1466 during Backup   General Data in Customer Master  
This documentation is copyright by IBM.
SAP E-Book


Message : CPA58FC
Controller &24 not contacted, connect retry limit reached. (C G R)

Message Long Text :

Cause . . . . . : The remote controller was polled while attempting to establish contact. No response was received, and the connect retry limit has been reached. The probable causes are:
-- The controller description may not be configured correctly.
-- The remote controller is powered off.
-- A network problem.
-- A local hardware problem.
Recovery . . . : Do one or more of the following:
-- Ask the remote system operator to determine if any problem or configuration error exists at the remote system.
-- Use the Work with Line Description (WRKLIND) command to display line &23 or the Work with Controller Description (WRKCTLD) command to display controller &24. Examine the value of the following parameters:
IDLCCNNTRY - Connect retry count
IDLCRSPTMR - Response timer
If the value of either parameter is set too low, it may not allow enough time for the remote system to respond. If either parameter is set to a low value, increase the value of the parameter and try the operation again.
Note: If a value for a parameter is specified on the controller description it overrides the value specified for the same parameter on the line description. If a value for a parameter is not specified on the controller description, the parameter value on the line description will be used.
Reply to the message.
If the problem continues, press F14 to run problem analysis.
Possible choices for replying to message . . . . . . . . . . . . . . . :
C -- Cancel recovery and inform any applications that are waiting for an operation that the recovery has been canceled.
G -- Start the automatic communications recovery again as defined by the communications recovery limit (CMNRCYLMT) configured for controller &24.
R -- Try again one more time.
Technical description . . . . . . . . : The error log identifier is &22. The error code is &40.

Message File : QCPFMSG
Library Message File : QSYS2924


BAL Application Log Documentation   General Data in Customer Master  
This documentation is copyright by IBM.

Length: 3282 Date: 20201029 Time: 023810     sap01-206 ( 4 ms )