Ansicht
Dokumentation

QRY2286 - Floating-point field &7 in error. ( OS/400 )

QRY2286 - Floating-point field &7 in error. ( OS/400 )

General Material Data   Addresses (Business Address Services)  
This documentation is copyright by IBM.
SAP E-Book


Message : QRY2286
Floating-point field &7 in error.

Message Long Text :

Cause . . . . . : The query did not run because an error occurred during floating-point calculations on a record in member &5 in file &3 in &4. This error is in one of the following:
- Field &7 of record &28,
- A result field that refers to field &7 in the expression defining that result field, or
- The calculation of that result field.
This error was caused by a floating-point value that:
- Exceeded the maximum representable value,
- Was less than the minimum representable value,
- Is not a number and, therefore, could not be mapped from double to single precision or from single to double precision,
- Is not a number and, therefore, could not be allowed as a key value,
- Could not be mapped to a packed decimal, zoned decimal, or binary value, or
- Lost at least one bit of precision while being mapped (into a floating-point field).
Recovery . . . : Check your calculations and the length of the field in error, make the necessary corrections, then run the query again.

Message File : QQRYMSG
Library Message File : QSYS2924


Vendor Master (General Section)   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3235 Date: 20240329 Time: 065756     sap01-206 ( 3 ms )