Ansicht
Dokumentation

CNV_CMIS_U_SXMS_XPRA_XI30_CONF - XPRA Report to Adjust TUNING Configuration Parameter to XI 3.0

Purpose

In XI 3.0, a sender or receiver is no longer identified by an identifier, but by a set of parameters. This means that the XI 2.0 configuration table can no longer store this information and cannot be extended since only the field SUBPARAMETER is available. Therefore, an additional table is required, which has already been created in XI 3.O for another purpose, namely SXMSINTERFACE. The parameters are:

o,,EO_INBOUND_PARALLEL_SENDER

o,,EO_OUTBOUND_PARALLEL

o,,EO_OUTBOUND_PARALLEL_SPLIT

In XI 2.0, you can specify multiple subparameters for these parameters, which are then interpreted as business systems.

The task of the XPRA report is to write the data from the configuration table to the new table (Subparameter = Business System = Sender/Receiver ID) and to then adjust the entries in the configuration table so that they reference the entries in the new table. The entries only need to be changed if a business system contains lower case characters. In this case, it cannot be used as a reference to SXMSINTERFACE since the receiver/sender ID in the table only permits upper case characters. The entry in the configuration is therefore replaced with a converted subparameter written in upper case.