Ansicht
Dokumentation
GRAPHICS_IGS_RSPO_TEST - Report GRAPHICS_IGS_RSPO_TEST
Vendor Master (General Section) ROGBILLS - Synchronize billing plansThis documentation is copyright by SAP AG.
Purpose
Use this program to check SNMP Printer Status feedback via RspoConnector Interpreter of the IGS.
Integration
Prerequisites
The IGS must be installed and run against this system.
An RFC destination must be maintained in transaction SM59. You can find more information about this in the note 454042.
A printer must be set up in transaction SPAD that supports SNMP status feedback. This printer has to set up with Access Method S, L, U or C.
Access Method L, U, C printers must have a network name or IP address specified in its SPAD definition. Use tab 'Access Method' and button 'SNMP' in transaction SPAD to specify this information.
An Access Method S printer does not need to have its network name or IP address specified in SPAD. Since such a printer is accessed from SAPSprint its printer status may be queried from SAPSprint as well. SAPSprint need to support protocol version 229 for the SNMP query (use command 'sapsprint -v' to check out the protocol version of SAPSprint. The SAPSprint protocol version has to be explicitly mentioned in the output of that command. If not the protocol version of SAPSprint is lower than 229. Furthermore make sure that on the OS side the associated printer is connected via a TCP/IP port to the machine SAPSprint is running on. If not SAPSprint may not be able to query its status.
If an Access Method S printer has its IP address or network name specified in its SPAD definition, the system will try to access the printer directly and not via SAPSprint.
Features
Selection
Enter the RFC destination of IGS.
Enter the name of a printer that supports SNMP printer status feedback (see section prerequisites).
Standard Variants
Output
The following information should be displayed:
·,,Is IGS reachable.
·,,Is RspoConnector Interpreter loaded from IGS.
·,,Does the specified printer support SNMP printer status feedback.
·,,Could the printer be queried for status feedback.
·,,Printer status.
Activities
Carry out the test in SE38 as follows:
·,,Choose F8.
·,,Enter the RFC destination of IGS.
·,,Enter the name of a printer that supports SNMP printer status feedback (see section prerequisites).
The following information should be displayed:
·,,Is IGS reachable.
·,,Is RspoConnector Interpreter loaded from IGS.
·,,Does the specified printer support SNMP printer status feedback.
·,,Could the printer be queried for status feedback.
·,,Printer status.
Example
PERFORM Short Reference BAL Application Log Documentation
This documentation is copyright by SAP AG.
Length: 3074 Date: 20240531 Time: 062418 sap01-206 ( 52 ms )