Ansicht
Dokumentation

CPC8801 - Job ended abnormally for SNADS sender &3/&2/&1, serving *SNADS distribution queue &5 ( OS/400 )

BAL_S_LOG - Application Log: Log header data   BAL Application Log Documentation  
This documentation is copyright by IBM.


Message : CPC8801
Job ended abnormally for SNADS sender &3/&2/&1, serving *SNADS distribution queue &5

Message Long Text :

Cause . . . . . : The SNADS sender ended because of reason code &4:
01 -- Internal object error
02 -- Protocol error while connecting to remote receiver
03 -- Error in SNADS configuration file
05 -- A *SNADS queue was not configured for the connection associated with this sender job
06 -- Unknown error occurred
08 -- Error in SNADS distribution log
09 -- Unknown error while accessing distribution data
14 -- Error while opening SNADS ICF file
15 -- Protocol error during communications with remote receiver
16 -- Error while parsing data from remote receiver
21 - 27 -- Recoverable errors that only result here when the queue is configured as a manual queue or the sender job was started by a SNADS receiver on a remote system.
Recovery . . . :
01 -- End and start the QSNADS subsystem (ENDSBS and STRSBS commands).
02 -- The remote receiver did not give control to the sender. Correct the problem on the remote system and start the sender again.
03, 06, 08, 09, and 14 -- See the previously listed messages in the job log, correct any errors, and start the sender again.
05 -- Add or change a *SNADS distribution queue so that its connection information (remote location name, remote net id, local location name, and mode name) matches the connection information associated with this sender job.
15 -- The remote receiver rejected the distribution. SNADS protocols for sending the response were not followed. Correct the problem on the remote system and start the sender again.
16 -- The remote receiver rejected the distribution. The sender was not able to process the response that was returned. Correct the problem on the remote system and start the sender again.
21 - 27 -- Message CPI8805 describes these reason codes. For more information, either display the message (DSPMSGD command) or see the job log as CPI8805 may have been previously issued.
To start a SNADS sender again, do one of the following:
-- Send the entries on the queue (SNDDSTQ command or option 2 from the WRKDSTQ display).
-- Hold and release the queue (HLDDSTQ and RLSDSTQ commands or options 3 and 6 from the WRKDSTQ display) to ready the queue for normal sending.
Technical description . . . . . . . . : For reason codes 06, 09, 15, and 16, an entry has been created in the problem log. Use the WRKPRB command to report the problem.

Message File : QCPFMSG
Library Message File : QSYS2924


Fill RESBD Structure from EBP Component Structure   ABAP Short Reference  
This documentation is copyright by IBM.

Length: 3310 Date: 20240426 Time: 223347     sap01-206 ( 3 ms )