Ansicht
Dokumentation

CPF5903 - Mode &1 specified for remote location &3 not valid. ( OS/400 )

ABAP Short Reference   ROGBILLS - Synchronize billing plans  
This documentation is copyright by IBM.


Message : CPF5903
Mode &1 specified for remote location &3 not valid.

Message Long Text :

Cause . . . . . : The &6 command failed for remote location &3, device &2, mode &1, local location &4, and remote network identifier &5. One of the following has occurred:
-- The mode specified in the command either is not valid or cannot be found.
-- The mode specified in the command has not been configured properly.
-- The mode cannot be allocated to device &2 because the maximum number of modes are already allocated to the device.
-- The maximum number of conversations for the advanced peer-to-peer networking (APPN) location have been reached; therefore, the mode cannot be added to the location. Use the Display Network Attributes (DSPNETA) command to display the maximum conversation count for the location.
Recovery . . . : Do one or more of the following:
-- Verify the mode specified in the command has been created and properly configured.
-- Use the Display Mode Status (DSPMODSTS) command or the Display Device Description (DSPDEVD) command to verify if the maximum number of modes are already allocated to the device (14 if SNGSSN = *NO, 1 if SNGSSN = *YES). If so, try the request using one of the modes that is already started.
-- If the maximum number of conversations has been reached for an APPN location, do one of the following:
-- Use the Change Mode Description (CHGMODD) command to lower the maximum conversation count for the mode. Try the request again.
-- Use the Change Network Attributes (CHGNETA) command to change the maximum conversation count. For this new value to take effect, use the Work With Configuration Status (WRKCFGSTS) command and the Vary Configuration (VRYCFG) command to vary off all the device descriptions that have the same remote location name (RMTLOCNAME parameter) and local location name (LCLLOCNAME parameter) as device &2. Once all the device descriptions have been varied off, try the request again.
Allow the system support to vary the device descriptions on.

Message File : QCPFMSG
Library Message File : QSYS2924


RFUMSV00 - Advance Return for Tax on Sales/Purchases   Vendor Master (General Section)  
This documentation is copyright by IBM.

Length: 3253 Date: 20240426 Time: 173149     sap01-206 ( 3 ms )