Ansicht
Dokumentation

CPF7077 - Key mapping error on member &3. ( OS/400 )

Vendor Master (General Section)   BAL_S_LOG - Application Log: Log header data  
This documentation is copyright by IBM.


Message : CPF7077
Key mapping error on member &3.

Message Long Text :

Cause . . . . . : The operation to apply or remove journaled entries failed on journal receiver &4 in library &5 sequence number &8 because of a key-mapping error on member &3 file &1 in library &2. The apply or remove operation could not be performed because of a select/omit error, reason code &7. The reason codes and their meanings follow:
1 -- There is data in a decimal field that is not valid.
2 -- A significant digit was truncated.
3 -- A floating point value exceeded the maximum representable value.
4 -- A floating point value was less than the minimum representable value.
5 -- A floating point value that is not a number could not be mapped from double to single precision, or from single to double precision, or to binary.
6 -- A floating point value that either is not a number or is an infinite number could not be mapped to packed or zoned decimal.
7 -- At least one bit of precision was lost when mapping to a floating point field.
Recovery . . . : Use the DSPDBR command to identify all logical file members that are built over member &3 file &1 in library &2, and open each logical file member. The diagnostic messages that are sent at open time should indicate which records have the key-mapping errors. Correct any errors and try the request again specifying the sequence number of the entry where the operation failed (FROMENTLRG or FROMENT parameter).

Message File : QCPFMSG
Library Message File : QSYS2924


Addresses (Business Address Services)   PERFORM Short Reference  
This documentation is copyright by IBM.

Length: 3227 Date: 20240511 Time: 051846     sap01-206 ( 3 ms )