Ansicht
Dokumentation

CPFE058 - Error occurred on IPX circuit &1. ( OS/400 )

PERFORM Short Reference   ABAP Short Reference  
This documentation is copyright by IBM.


Message : CPFE058
Error occurred on IPX circuit &1.

Message Long Text :

Cause . . . . . : An error occurred on IPX circuit &1 established on line description &4, when the X.25 virtual circuit was reset or cleared. The cause code is &5 and diagnostic code is &6.
Recovery . . . : Do the following:
-- Use the Work with IPX Circuits (WRKIPXCCT) CL command to determine the current state of IPX circuit &1.
-- Check the QSYSOPR message queue for messages that refer to line description &4.
-- Use the Work with Configuration Status (WRKCFGSTS) CL command to ensure that line description &4 is operational.
-- Verify that the remote system associated with IPX circuit &1 is ready for communication with the local system.
-- After correcting any problems identified by doing the above actions, check the state of circuit &1 to determine if you need to end and restart it. To end a circuit use the End IPX Circuit (ENDIPXCCT) CL command. To start a circuit use the Start IPX Circuit (STRIPXCCT) CL command. command.
Technical description . . . . . . . . : The return code and associated data from the IPX support is &2/&3.

Message File : QCPFMSG
Library Message File : QSYS2924


Fill RESBD Structure from EBP Component Structure   BAL Application Log Documentation  
This documentation is copyright by IBM.

Length: 3227 Date: 20240426 Time: 112104     sap01-206 ( 4 ms )