Kontakt

Ansicht
Dokumentation

DIAG_CONN_AGENT_SLD - Connect Diagnostics Agent from SLD

DIAG_CONN_AGENT_SLD - Connect Diagnostics Agent from SLD

ABAP Short Reference   Fill RESBD Structure from EBP Component Structure  
This documentation is copyright by SAP AG.
SAP E-Book

In order to use a Diagnostics Agent that has been automatically installed with a SAP NetWeaver system installation based SR3 or later, the agent must be connected to the Solution Manager. Skip this step otherwise.

Go to the Agent Administration by http://>SOLMANHOST>:/smd/go/ADMIN_AGENT

And assign an Agent via the Agent Candidates Management.

This tool opens a new window and connects by default to the SLD using the connection settings declared via the “SLD Data Supplier Service” of the managing system:

  • If those settings are missing (or inconsistent), a message is displayed with the corresponding error message. If an error message appears, check your current SLD settings
  • If the connection to SLD succeeds the “Managing System Information” group displays information retrieved from the SLD about the managing system itself.

Select "Custom SLD Connection Parameters" check box and enter the connection information of the production SLD to which the SMD Agents are registered.

Click on Apply" Button.

At this point, two tabs are available:

  • SLD View
  • SMD View

The SLD View displays information retrieved from the SLD. A table displays the list of SMD Agent Candidates. If no SMD Agents are registered to the SLD the list is empty.

  • A column names “Associated To” gives the name of the system, the SMD agent is bound to. If the value is empty, it means that the SMD agent is not yet attached to a system; In this case the SMD Agent has the status called “candidate”.
  • A “State” icon gives the current status of the SMD Agent.

This view allows checking the list of SMD Agent registered to SLD and already connected to

the Managing System.

This view provides different information as:

  • Agent name
  • IP Address
  • Uptime Last Connection
  • Status
  • SLD Setting
  • Push SLD Setting Link

The “SLD Settings” column displays the connection settings used by the Agent to connect to the SLD.

The Push SLD Setting Link allows sending the SLD settings to the SMD Agent.

On the SLD View tab, select one of the candidate SMD Agents.

A new frame is displayed in the bottom of the screen. It allows to provide the User and Password to connect to the SAP Solution Manager.

  • The information is automatically send to the SMD Agents when pressing the apply button.
  • SMD Agent connects itself to the SAP Solution Manager.

Once the registration is over the agent is visible in the regular Agent Administration UI and its state in the list of candidates is (associated).

Agent reconnection may require waiting several minutes. It depends on settings which are set on the SMD Agent side. As soon as it detects that the association has been changed the SLD state is updated and the registration should proceed.






Vendor Master (General Section)   Fill RESBD Structure from EBP Component Structure  
This documentation is copyright by SAP AG.

Length: 3516 Date: 20240523 Time: 181243     sap01-206 ( 52 ms )