Ansicht
Dokumentation
ISHT_MES_SPC_02 - Define Valuation Mode
rdisp/max_wprun_time - Maximum work process run time General Data in Customer MasterThis documentation is copyright by SAP AG.
In this step, you can:
- Define how a decision is made to accept or reject inspection characteristics (valuation mode). These decisions are used in the sampling procedure.
- Integrate IS-HT function modules that allow you to make the decision whether to accept or reject inspection characteristics.
- 800 - SPC Inspection (the standard mode 800 must be deleted first)
- 900 - SPC Inspection P-Charts
- 910 - SPC Inspection U-Charts
- U10 - Attributive Percentage
The IS-HT-MES specific valuation modes are based on the IS-HT-MES specific valuation rules. Therefore the valuation rules must be set up prior to performing this action.
Set up the valuation modes using the following settings:
- Mode 800
- Short Text - SPC Inspection
- Definition - Quality Control Chart Action Limits
- Valuation Rule - 80
- Mode 900
- Short Text - SPC Inspection P-Charts
- Definition - Attributive inspection by no. of nonconf. units
- Valution Rule - 90
- Mode 910
- Short Text - SPC Inspection U-Charts
- Defintiion - Attributive inspection by no. of defects
- Valuation Rule - 91
- Mode U10
- Short Text - Attributive Percentage
- Definition - Attributive Inspection by no. of nonconf. units
- Valuation Rule - 94
- Delete existing valuation mode 800.
- Create valuation rules 800, 900, 910 and U10.
- Save your entries.
PERFORM Short Reference rdisp/max_wprun_time - Maximum work process run time
This documentation is copyright by SAP AG.
Length: 2678 Date: 20240523 Time: 201541 sap01-206 ( 25 ms )