Ansicht
Dokumentation
ISP_PARAMETERS - Define Internal SyncPoint Settings
BAL_S_LOG - Application Log: Log header data RFUMSV00 - Advance Return for Tax on Sales/PurchasesThis documentation is copyright by SAP AG.
You must define parameter values for RFC communication for the MapBox, the maximum number of message processing attempts (in case of an error), and a timeout value for the Payload Interface session.
Perform the individual steps as follows:
- Enter the MapBox RFC Destination in the Configuration Table
- To call the MapBox, you must enter the name of the RFC destination you created.
- You can create different entries for each site type. If no site type specific entry exists, the generic entry without a site type is effective. If no entry exists (with or without site type), an error is raised during the processing of messages in the Internal SyncPoint.
| Parameter Name | Site Type ID | Parameter Value |
|---|---|---|
| MAPBOX_RFC_DESTINATION | GWA_01 | |
| MAPBOX_RFC_DESTINATION |
- Limit the Number of Processing Retries
- You may enter a limit for the number of retries that are performed when the processing of any message results in a temporary error. The time interval between two attempts is determined by the qRFC Inbound Queue scheduler. If the error condition persists even after the maximum number of retries, a fatal error will be raised. A temporary error may occur if, for example, the data that the MapBox needs to complete the mapping is not available.
- You can create different entries for each site type. If no site type specific entry exists, the generic entry without a site type is effective. If no entry exists (with or without site type), the default value of 5 retries is considered.
| Parameter Name | Site Type ID | Parameter Value |
|---|---|---|
| MAX_RETRIES | GWA_01 | |
| MAX_RETRIES |
- Define Session Timeout for Payload Interface
- You may enter a default value (specified in seconds) for the inactivity timeout for any session of the Payload Interface. After the session is established, the client application may override this value. If a session is inactive (no methods of the Payload interface are invoked) for a longer time than specified, the session handle is timed out and therefore invalid.
- You can create different entries for each site type. If no site type specific entry exists, the generic entry without a site type is effective. If no entry exists (with or without site type), the default value of 300 seconds is considered.
| Parameter Name | Site Type ID | Parameter Value |
|---|---|---|
| PIF_TIMEOUT | GWA_01 | |
| PIF_TIMEOUT |
Addresses (Business Address Services) TXBHW - Original Tax Base Amount in Local Currency
This documentation is copyright by SAP AG.
Length: 4108 Date: 20240523 Time: 153823 sap01-206 ( 58 ms )
