Kontakt

Ansicht
Dokumentation

MASCHINELL_MAHNSTUFE - Define Dunning Level Determination

MASCHINELL_MAHNSTUFE - Define Dunning Level Determination

Vendor Master (General Section)   Addresses (Business Address Services)  
This documentation is copyright by SAP AG.
SAP E-Book

In this IMG activity you fix the dunning levels assigned by the system in each dunning run, depending on the number of overdue payment installments and the dunning level previously assigned to the contract, the main borrower or the finance project.

  • You need to have defined a valid dunning procedure in the Implementation Guide for Financial Accounting, in the IMG activity Define Dunning Procedures.
  • To ensure that the system takes account of the dunning level determination that you set here, you need to activate the extended dunning for the product type that is using the dunning procedure. You do this in the IMG activity Define Product Types
Note
You can only activate the extended dunning for product types that are based on the Consumer Loans (340) category.

  1. Select the dunning procedure for which you want to fix the dunning level determination.
  2. Select New Entries.
  3. In the fields Installments from and Installments to, set the areas for the dunning levels.
  • Make sure that the areas are completely covered. This means that the value in the Installments tofield in the previous entry must equal the value in the next entry.

  • If the dunning level for a contract, a main borrower or a finance project is exactly equal to the Installment to value of an area or the Installmentfrom value of the next area, the system uses the valuesfrom the larger of the two areas as the basis for determining the dunning level determination.

  • Make sure that the Installment to value of the final entry is 0. This has the effect that the largest area of overdue installments includes all values that are larger than the Installment from value in this area.

  1. In the fields Old DL 0,1,2 and so on, enter the new dunning level that the system is to assign during the dunning run, depending on the old dunning level.
The number of fields Old DL 0,1,2, and so on corresponds to the number of dunning levels that you have assigned for the dunning procedure, plus the Old DL 0 field.
  1. Save your entries.

For a dunning procedure with 4 dunning levels you could set up the dunning level determination as follows:






Fill RESBD Structure from EBP Component Structure   Vendor Master (General Section)  
This documentation is copyright by SAP AG.

Length: 5097 Date: 20240523 Time: 184915     sap01-206 ( 62 ms )
Installment from Installment to Old DL 0 Old DL 1 Old DL 2 Old DL 3 Old DL 4
0.05 0.50 1 1 1 1 1
0.50 1.00 1 2 1 2 1
1.00 1.50 2 2 3 2 3
1.50 1.75 2 2 3 2 4
1.75 2.00 2 2 3 2 4
2.00 0.00 2 2 3 2 4