Ansicht
Dokumentation

REFXV_TIVAJSPECTASK - Define Parameters for Adjustment Rule

Vendor Master (General Section)   rdisp/max_wprun_time - Maximum work process run time  
This documentation is copyright by SAP AG.

You can specify here how the values entered in the actual adjustment method are included in the calculation of the new rent. This applies to adjustment rules using the Adjustment Measure method.

You defined an adjustment rule that is based on the Adjustment Measure method, and set up all cross-method parameters for it. Create an entry here for each adjustment rule that you assigned to the Adjustment Measure (TASK) method. Specify the values for the parameters explained below.

Specify the following parameters for the adjustment rule:

• Enter the adjustment measure type.
  The adjustment measure type determines which field status variants are possible. In addition, the method implemented for the calculation of the new condition amount can be dependent on this adjustment type.

• Enter the field status variant that you want to use for this adjustment measure.

• Enter the Percentage Surcharge, and the Time in Months that this percentage relates to.
  For example, in the case of a modernization, only part of the value entered on the adjustment measure might be used for calculating the new condition amount. If that is the case, then you enter the percentage rate to be used here.

• Enter the Measurement Type that you want to use for distributing an overall total amount to all rental objects involved in the adjustment measure. You do not need to enter a measurement type unless you want to distribute an overall value. If you do want to distribute, then you also need to enter the unit of measurement. The system may have to convert to this unit of measurement.

• Specify the Rule for Limit that the system uses when calculating the amount that acts as the basis for determining an upper limit for the new condition amount. For example, you could specify that a rent is calculated based on the representative list of rents. Using the Factor for Limiting Amount, you can specify that the upper limit that is calculated is weighted with this factor.
  For example, you choose the Representative List of Rents rule and a factor of 1.2 for an adjustment due to modernization. This ensures that the new rent is no more than 20% above the standard local rent as defined by the representative list of rents.

• You use the Adjustment Type to specify what objects are adjusted. Usually you enter only rental objects on the adjustment measure. The system can, for example, then perform the adjustment for the valid lease-out contract and the object (or for the assessment contract and the object).

• In the Currency field, you specify the default value for the currency of the amounts that are entered on the adjustment measure.

• Set any other indicators that you want to apply for this adjustment rule. For information on these indicators, see the F1 Help.

rdisp/max_wprun_time - Maximum work process run time   CPI1466 during Backup  
This documentation is copyright by SAP AG.

Length: 3752 Date: 20240523 Time: 205614     sap01-206 ( 73 ms )