Kontakt

Ansicht
Dokumentation

SIMG_CFMENUOLQSOQCE - Define Tolerance Keys

SIMG_CFMENUOLQSOQCE - Define Tolerance Keys

BAL Application Log Documentation   PERFORM Short Reference  
This documentation is copyright by SAP AG.
SAP E-Book

Allows you to define the tolerance keys for quantitative characteristics with tolerance ranges.

In this step, you can define the tolerance keys for quantitative characteristics with tolerance ranges.
If this configuration is used to define measurement tolerances in the mechanical engineering sector, the terms 'target value' and 'limiting value' are synonymous for the terms 'nominal value' and 'limit deviation'.
For each tolerance key, you can define:

  • A short text
  • A unit of measurement
  • The number of decimal places for the target value and specification limits
    Note: Although you can enter a different number of decimal places for the nominal value and limit deviation from that in the tolerance key itself, the system always uses the number of decimal places specified by the tolerance key in the inspection characteristic.
  • The target value
  • Whether the target value in the key should be copied into the characteristic
  • The limiting values as absolute values or differences to the target value (relative tolerance)
  • Whether the relative tolerance depends on the target value; if this is the case, you must define the relative tolerances for each target value range in a subordinate table.

You have defined the units of measurement.

You have defined the units of measurement.

The standard system contains complete tolerance tables for holes and shafts according to DIN ISO 286-2.

Note:
SAP assumes no liability for the validity of the data.

  1. Determine whether tolerance schemes for quantitative characteristics are used in your company and find out how you can represent them in the SAP component QM.
    If your company is active in the mechanical engineering sector, you can use the tolerance tables for limit deviation in the standard system for holes and shafts.
  2. Store the tolerance specifications in the table.

Normally, companies in the relevant industry sectors need only a small selection of the tolerance tables in client 000.

To copy this data into the current client, use the function provided in the table maintenance (Utilities -> Adjustment with client 000) and its associated copy function.

Setting Up Clients in the Basic Settings section contains instructions on how you can transport all of the basic settings in the standard client 000 to the current client.






Fill RESBD Structure from EBP Component Structure   PERFORM Short Reference  
This documentation is copyright by SAP AG.

Length: 2839 Date: 20240523 Time: 204120     sap01-206 ( 48 ms )