Ansicht
Dokumentation

SIMG_ME_MEUMG - Define Unit of Measurement Groups

BAL_S_LOG - Application Log: Log header data   ROGBILLS - Synchronize billing plans  
This documentation is copyright by SAP AG.

In this IMG activity, you set up a unit of measure group. A Unit of Measure Group defines a set of standardized measurement units for use in a particular environment.

In order to make the integration between the PRA Solution and the Measurement System flexible, the Measurement System can be configured to display readings with units of measure in a specific Unit of Measure Group. This allows the system to be configured for multiple situations. This is possible as long as the Unit of Measure Group is defined in the Measurement System and is tied to a Reading Type. (Each Reading Type is defined with a Unit of Measure Group and possibly a unit of measure.)

Once the Unit of Measure Groups are configured in the Measurement System and tied to Reading Types, the output will display units of measure in the defined Unit of Measure Group for the particular reading.

In addition, Unit of Measure groups are assigned to delivery networks, and they control the target units for the quantity conversion interface (QCI) calculations in the PRA system. An entry is needed for the Unit of Measure Group that QCI will use. Once you enter a Unit of Measure Group, you must tie the specific Units of Measure that will be standardized to that group.

Example

UoM group UG1 (US Gas at 15.025 psi, 60°F) contains the following standardized measurement units:

BC1,,BTU/cubic foot at 15.025/60/SD

MBD,,one million BTU (60 FAH, SD)

MC1,,one thousand cubic feet

Requirements

A Unit of Measure Group is attached to all well completions and measurement points being used in order for the Measurement System to determine which units of measure to display for the readings.

Standard settings

The standard system is provided with the following configured Unit of Measure groups:

EU1,,European Standards Unit of Measure

GS1,,Natural Gas Selection

GS2,,Masses and Energies

GS3,,Volumes and Energies

GSE,,Energies only

GSM,,Masses only

GSV,,Volumes only

ISO,,ISO units for Natural Gas

NA1,,North American Measurements

UG1,,US Gas at 15.025 psi, 60°F

UG2,,US Gas at 14,73 psi, 60°F

UG3,,US Gas at 14,65 psi, 60°F

USG,,NA Liquid Gallons

USL,,NA Liquid Barrels

Recommendation

The standard setup should be sufficient for most applications.

Activities

1. Choose Units of measure group.

2. Choose New entries. Then add the new Unit of Measure Group code and its description.

3. Choose Assignment to unit of measure.

4. Assign the required units of measure.

5. Save the unit of measure group.

6. Go to the Reading Types configuration and add the Unit of Measure Group. Then, if necessary, add the appropriate unit of measure to each Reading Type.

Further notes

See Define Reading Types for additional information.

Vendor Master (General Section)   CPI1466 during Backup  
This documentation is copyright by SAP AG.

Length: 3338 Date: 20240523 Time: 191135     sap01-206 ( 55 ms )